where/how can i............

[Thumper]

hi all

i was just wondering if any of ya would help me out a sec
here go's

how do i change the gearing to 18:41
how do i lockwire the oil filter cap
how do i lockwire sump plug and the bolt next to i how can i fit a catch tray
how can i put a catch tank on for the 2 carb overflow pipes

where can i get a good chain
where can i get some rear pads
and last of all where can i get some quality springs for standard thump forks
(pro 120) not the elite

If you can give me one of these that is fine
and any numbers of suppliers for the chain etc

thanks very much

tom

[paul *1*]

have you asked phoenix racing about any of this:confused: :confused:

[Thumper]

yes but there crap

[RUMotarded]

hi all

i was just wondering if any of ya would help me out a sec
here go's

how do i change the gearing to 18:41
how do i lockwire the oil filter cap
how do i lockwire sump plug and the bolt next to i how can i fit a catch tray
how can i put a catch tank on for the 2 carb overflow pipes

where can i get a good chain
where can i get some rear pads
and last of all where can i get some quality springs for standard thump forks
(pro 120) not the elite

If you can give me one of these that is fine
and any numbers of suppliers for the chain etc

thanks very much

tom

What is your stock gearing? If you have a 16 front standard and going to 18, you will probably have to cut the stator cover because it will rub. Better off going 17 and going smaller on the rear.

To lockwire....
Oil fill - drill small hole through the tab and wire it to something fixed so it can't turn counterclockwise
Oil drain - drill hole through bolt head and wire as above
Cam tensioner bolt - same as above (there's a spring behind this bolt, be sure to remember which way it came out)

Oil catch tray - bottom 1/3 of a 5 litre fuel can, zip tie it to your skid plate

Fuel catch - any can/plastic bottle bigger than 250ml, run both pipes into it and make sure there is an additional hole to vent (bike will cut off if blocked)

Try minixuk or monkeybike.co.uk for bits

Hope that helps!