Pit Bike Club - View Single Post

Creamsodauk · 08-10-2015, 12:57 PM

Picked up washers 3mm thick 16mm id and 30mm od

So I have had a go at fitting the rear wheel and with success

I made spacers up with washers to make the wheel alignment spot on!

But when you tighten the wheel up you crush the bearings and the wheel becomes tight, how do you go around this other then too loosen the bolt off a bit ?

Also the wheel spacers have lips that fit into the original wheels, the right hand spacer does fit into the mag wheel fine, however the left spacer lip does not fit into the mag wheel

If I buy spacers too match the width of my washers which fit perfect what do I do about the lip on the apacer as this won't fit into the wheel like it's designed and will push the spacer out wider

Any help appreciated guys 8-)

08-10-2015, 12:57 PM	#8
Creamsodauk On Stabilizers Join Date: Jul 2015 Age: 36 Posts: 52 Bike: Honda Msx	Re: Mag wheels don't fit Picked up washers 3mm thick 16mm id and 30mm od So I have had a go at fitting the rear wheel and with success I made spacers up with washers to make the wheel alignment spot on! But when you tighten the wheel up you crush the bearings and the wheel becomes tight, how do you go around this other then too loosen the bolt off a bit ? Also the wheel spacers have lips that fit into the original wheels, the right hand spacer does fit into the mag wheel fine, however the left spacer lip does not fit into the mag wheel If I buy spacers too match the width of my washers which fit perfect what do I do about the lip on the apacer as this won't fit into the wheel like it's designed and will push the spacer out wider Any help appreciated guys 8-)