velocity stacks

[beechin]

want one for my bike. iv got a vm26 carb and cant find one to fit. i want long one for the lower end grunt. if you have got on please post a link to were you got it or if you fancy selling it pm me.

[bennell09]

Originally Posted by beechin

want one for my bike. iv got a vm26 carb and cant find one to fit. i want long one for the lower end grunt. if you have got on please post a link to were you got it or if you fancy selling it pm me.

heres loads mate

http://www.ooracing.com/store/index....ewCat&catId=42

[beechin]

iv already looked at them. i emailed them earlia and they said that that most have a 46mm stub size and the vm26 is a 42mm sub size so they would be slightly to big.

[beechin]

anyone else know were i can get one to fit.

[Bmp-Productions]

i beleive the 46mm will fit, on colonels bike i see there were four screws which you tighten until its tight against the carb?

[beechin]

i no the 46mm will fit but there will b a 4mm gap between the stub of the stack and the carb just want to no if this will be ok.

[Bmp-Productions]

Originally Posted by beechin

i no the 46mm will fit but there will b a 4mm gap between the stub of the stack and the carb just want to no if this will be ok.

pm colonel he'll tell ya, i should think so, may look a little bit odd but if not just pack the 4mm area out with rubber sheath?

[Colonel]

Mine's not actually a proper stack for the vm26. It's a chopped stack off god knows what. I drilled it and put screws round to hold it in position and then used silicone sealant to fill the gap.

[beechin]

yh i tought that or maye abit in foam tape that should do it surly.

[pitbikeingmad]

colonel, can you pm me a good set up with vm26 genuine, and stack? Set up for my motor?

Law