I am going to check my valve clearances tonight on my WPB 125.
In the book it states that you should use 0.05mm on Inlet and Exhaust which equates to 0.002". But a quick look on the web shows a number of other values. Also they usually give a larger gap for the exhaust.
So my question is what clearances are other people running on a WPB 125? Or does 0.0022 seem about right?
Cheers for the vid mate... but I have set valve clearences before
I am just wondering what differences it makes running a bigger gap. I prob dont make any difference so I will just stick with what the book says.
whith a smaler gap the metal expands and pushes the valves in slightly when hot which looses compresion so bigger gap = it can expand and not push the valves in loosing no compresion
whith a smaler gap the metal expands and pushes the valves in slightly when hot which looses compresion so bigger gap = it can expand and not push the valves in loosing no compresion
in extreme cases what happens is the top of the valve melts into your rocker arm