Go Back   Pit Bike Club > Pit Bike Club General > Off Topic Discussion > Introductions

Latest discussions at Pit Bike Club:

  • New Member
    Hi all, new here bit of intro. Im scott, not new to pitbikes but been out of the bike mix for last 10 years. Recently...
  • Hi
    Hi new member south wales...
  • New to it all looking for places to ride in Steven...
    Hi everyone I’m new to pit biking and hoping for some guidance around places to practice I am near Knebworth side of...

Reply
 
Thread Tools Display Modes
Old 20-04-2019, 11:35 PM   #1
Rickwales
Super King
 
Rickwales's Avatar
 
Join Date: Jul 2017
Age: 55
Posts: 1,060
Bike: stomp
Re: Hello

That's probably the idle screw. You need to clean the car properly . Take the jets out and also make sure the emulsion tube is clear and also the bypass air inlet that goes in from the air filter side is clear. My bike was the same when I had it and once I reset the valve clearance and sorted the carb properly it run like a dream
Rickwales is offline   Reply With Quote
Reply