Go Back   Pit Bike Club > Pit Bike Discussion & Reviews > Pit Bike Discussion

Latest discussions at Pit Bike Club:


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-12-2009, 12:48 PM   #11
WPB Pitbikes
PBC Legend
 
WPB Pitbikes's Avatar
 
Join Date: Oct 2006
Location: Welsh Pit Bikes
Posts: 5,387
Bike: WPB 2WIN
Re: stomp owners manual - get in NOW ONLINE

Chain


Lubrication


, keep your chain lubricated & clean is thoroughly after use, we recommend a dry wax such as Putolene tech chain (available direct

from Stomp or all good motocross outlets).


Tension is also very important, when you ride your bike, your chain will stretch, especially when it’s

new. Keep an eye on the up & down free play of your chain at it’s longest section. Approx 2.5 inches from top to bottom is acceptable. When


you adjust it put your full body weight down on the suspension to check the tension when fully loaded, on some models the tension can increase


with suspension movement. If you chain is rattling, it’s probably too loose. A loose chain can come off & damage your engine cases, chain



guard or worse still, your leg. Keep a check on it.


Air Filter


Keep it clean with putolene filter cleaner & then oil it up with putolene filter oil before you next use your bike. Dust, Grit & Dirty water can get in


your engine & this will significantly reduce the life of your piston rings. In extreme cases your piston & barrel can be damaged. We advise that


you replace your standard filter after 10 hours use & replace it with an improved quality aftermarket filter such as UNI (available direct from all



good stomp dealers). These then need to be replaced every 20 hours. You wouldn’t drink dirty water so don’t let your engine breath dirty air.


Bearings


Keep a close eye on your bearings, in particular head set, swing arm & wheel bearings. These ALL take a severe pounding and are subject to


all the dirt & grit associated with an off-road machine. Typical wheel bearing life is around 10 hours in severe riding conditions. Swing arm 20


hours & headset 20 hours. Keep them clean & from time to time pop off the dust seals where applicable & re-grease. Water & jet washing will



wash away wheel bearing & swing arm bearing grease. Never directly point your jet wash at bearings. If you look after your little balls you will


get more out of them


Cables


Keep them lubed up with putolene cable lube. If you keep them clean & lubed up they will last longer, your bike will be safer to ride & improve


your control.
WPB Pitbikes is offline   Reply With Quote
 


Similar Threads
Thread Thread Starter Forum Replies Last Post
M2R KMX140 CRF70 - Owners Manual mwg_ Pit Bike Discussion 1 08-05-2013 10:33 PM
Stomp owners manual online Smugger_69 The Workshop 0 21-02-2011 10:38 PM
F.A.O stomp KZ owners!! englishjenny Pit Bike Discussion 25 10-08-2010 06:44 PM
owners manual 4 stomp macpaddy5 Pit Bike Discussion 1 11-10-2009 09:45 PM
VM26 owners Free Tuning manual same as ebay item Lewis_#101 PBC Tutorials 0 24-06-2006 10:28 PM